SOLARION AI
Catalogue and datasheet audit. We recalculate your published figures: inertias, weights, load limits, maximum sizes. We tell you which do not add up, with the calculation alongside. In writing, in private
In one catalogue we audited, 15 of 74 references did not reproduce their own figures. Do yours?
Other products & services
Custom software for manufacturing. Production control, batch traceability, quotation management and invoicing, connected to the ERP you already run. Not a licence full of modules you do not need: the missing piece
We do not replace what already works. We write the missing piece and connect it. And if it has to calculate, it does
Technical catalogue digitisation. We turn your catalogue into structured data, reference by reference, with every figure recalculated and every contradiction flagged. Ready for your website, your ERP or a configurator
Your technical data is correct, but it only exists inside a PDF. It cannot feed your website or your ERP
Custom regulatory calculation engines. We put the rule your product has to meet inside the software: it applies itself, every figure carries its source on screen, and it warns you when the rule is not met
A regulatory table is not interpolated. The engine always takes the more demanding cell, and states its source.
Automated dimensioned DXF drawings and cutting lists. The configurator outputs the file that goes into your cutting chain: DXF R12 on separate layers, with a dimension chain, a section detail and a title block
The warnings are written inside the DXF. A drawing gets forwarded, and the screen it was made on does not
Automated quoting for made-to-measure products. The price comes from the real bill of materials: stock with scrap, shop hours, manufacturability surcharges, margin by family and discount bands. Not a flat price list.
The price comes from the real bill of materials, not a flat list. And if a price is missing, it says so.
Prototype configurator in 10 working days. One family of your product, working and actually calculating: 3D, bill of materials, DXF drawing and price. 50 places. Requirement: bring your sections as DXF or STEP
50 places
SOLARION FORGE, manufacturing platform. It starts from the part, not the catalogue: which sheet or billet it comes from, what size to order, how much is lost as chips, and the real cost. Holes, cuts, bending. Multi-user
It does not estimate by the kilo: it works out the stock, the chips lost and the real cost
3D configurator with a calculation engine. Change one dimension and out come the bill of materials, the cutting list, the weight, the DXF drawing and the price. If it cannot be made, it says why.
If the size cannot be manufactured, it refuses to quote and explains why. Cut list and DXF included.